___________________________________________________________

**The Question**

___________________________________________________________

Given a length of square stock and a standard compound miter chop-saw how would you make an equilateral triangle using only 45 degree cuts?

___________________________________________________________

___________________________________________________________

This is a woodworking math puzzle I invented. For three years now no one I've asked

has been able to answer the question.

________________________________________________________

___________________________________________________________

**The Hints**

___________________________________________________________

You need only set up the saw once

You may fashion a simple length stopYou will make exactly four cuts

__________________________________________________________

**The Answer**

___________________________________________________________

Set the saw to a 45 degree x 45 degree compound cut as shown.

Cut off the tail of the stock.

___________________________________________________________

*partial rotation shown*

___________________________________________________________

Slide stock to the stop.

___________________________________________________________

Make the second cut.

rotate stock 180 degrees and slide to stop

___________________________________________________________

With exactly four cuts you can generate three parts.

___________________________________________________________

___________________________________________________________

Rotate one part around the fold axis.

Fold the second part over by 90 degrees.

Here is an equilateral triangle made from only 45 degree cuts.

**That's It!**

___________________________________________________________

___________________________________________________________

**There is More!**

___________________________________________________________

It's interesting that the two angled sides

of the triangle are not the same.

Depending on the respective orientation from these triangles

one can make edge truncated octahedrons and tetrahedrons.

of the triangle are not the same.

Depending on the respective orientation from these triangles

one can make edge truncated octahedrons and tetrahedrons.

Consequently it follows that one can generate an octet-truss.

___________________________________________________________

___________________________________________________________

___________________________________________________________

___________________________________________________________

**Photos**

___________________________________________________________

These alder frames are glued and nailed.

_________________________________________________________

Three triangles preparing to merge.

___________________________________________________________